Effector Fx Module [verified] -

| Category | Examples | Common Controls | |----------|----------|------------------| | | Delay, Echo, Reverb | Time, Feedback, Damping, Decay | | Modulation | Chorus, Flanger, Phaser, Vibrato | Rate, Depth, Feedback, Phase | | Dynamics | Compressor, Limiter, Gate | Threshold, Ratio, Attack, Release | | Distortion/Saturation | Overdrive, Fuzz, Wavefolder | Drive, Tone, Mix | | Filter | Low-pass, High-pass, VCF | Cutoff, Resonance, Envelope amount | | Pitch/Frequency | Pitch shifter, Frequency shifter | Shift amount, Delay, Feedback | | Multi-FX | Combined (e.g., Mimeophon, FX Aid) | Varies, often with presets |

| Problem | Solution | |---------|----------| | Signal too hot / clipping | Reduce input gain or use attenuator before module. | | Loss of low end | Use a dry/wet mix or parallel process. | | Unwanted noise | Check power supply; use balanced cables where possible. | | CV not responding | Ensure voltage range matches (0–5V, -5–+5V, 0–10V). | effector fx module

: The central interface is a large X/Y pad. Moving your mouse or a controller across this grid manipulates two parameters simultaneously, allowing for expressive, fluid sound changes. | Category | Examples | Common Controls |